Respawn Problem

Discussion in 'Mapping Questions & Discussion' started by RedTr4, May 22, 2010.

  1. RedTr4

    RedTr4 L1: Registered

    Messages:
    3
    Positive Ratings:
    0
    I built a large room with two respawn corner rooms inside the large room. I add a cube that is touching the inner walls, floor and ceiling and set it to func_respawnroom. Then I created 8 entitys in each corner room set to info_player_teamspawn. Every time I run the map I spawn outside underneath the large room. I have triple checked all the respawn entities and there all hovering above the floor and not touching anything.

    Please help!!!

    Thanks
     
  2. Crash

    aa Crash func_nerd

    Messages:
    3,063
    Positive Ratings:
    4,550
    Have you tried moving each spawn point higher off the ground? Like a good 16 or so units?
     
  3. DjD

    DjD L5: Dapper Member

    Messages:
    230
    Positive Ratings:
    55
    You should make sure that this "cube" has the orange so called 'trigger texture' on it, thats the only thing I could think of since u said the spawn points are not touching the ground.
    Also make sure that the spawn points are not touching each other.

    Depsite that, double click the respawn entities and select the right team (Red/Blue)
     
  4. Bad Vlad

    Bad Vlad L2: Junior Member

    Messages:
    71
    Positive Ratings:
    16
    You need to put your info_player_start (or whatever entity handles spawn points) slightly above the ground or you'll spawn under it.