Displacement question

Discussion in 'Mapping Questions & Discussion' started by Stormcaller3801, Jul 10, 2009.

  1. Stormcaller3801

    Stormcaller3801 L5: Dapper Member

    Messages:
    249
    Positive Ratings:
    28
    Let's say I've got a slope, maybe... oh, let's call it a rise of 100 and a run of 150, width of 200. Simple wedge, and both ends of this wedge share edges with blocks. Is it going to be a pain in the butt to do displacements that merge across all three, or is that not much more difficult than dealing with standard cubes and so forth?
     
  2. Psy

    aa Psy The Imp Queen

    Messages:
    1,705
    Positive Ratings:
    1,465
    Displace the top face and, as long as the slope has a common edge with the two faces at either end, they will sew together.
     
  3. zornor

    zornor L4: Comfortable Member

    Messages:
    195
    Positive Ratings:
    23
    No matter what gradient other edges are in relation to the common edges you're trying to sew it won't make a difference, if that's what you're asking. Basically it will work like a cube.
     
  4. Stormcaller3801

    Stormcaller3801 L5: Dapper Member

    Messages:
    249
    Positive Ratings:
    28
    Alrighty, thank you. I was concerned that it would cause problems due to the angle and dimensions and so forth.