A circle in the ground

Discussion in 'Mapping Questions & Discussion' started by zahndah, Sep 29, 2015.

  1. zahndah

    aa zahndah professional letter

    Messages:
    718
    Positive Ratings:
    627
    In my map for the dynamic cp contest, I want the capture point to be above a medium sized cylinder cut out of the ground, and I have made this (without the carve tool) but now I see loads of tiny <1 hu holes in the ground where I missed parts of the floor. I have completely made a mess of it and am wondering if the manual method or carve is actually better. I know carve is bad, especially with circles and things but I could carve it in 30~ seconds or spend 2~ hours filling in holes or spend time redoing it, and to be honest i reckon carving would give me a better result than me doing it manually. Please say what you think I should do / help me out with how to not make a mess of the floor around the cylinder.

    The point:
    Screenshot (16).png
     
  2. killohurtz

    aa killohurtz Distinction in Applied Carving

    Messages:
    1,006
    Positive Ratings:
    1,160
    • Thanks Thanks x 1
  3. zahndah

    aa zahndah professional letter

    Messages:
    718
    Positive Ratings:
    627
    Ah, yes thank you.