Working with cylinders in Hammer

Discussion in 'Mapping Questions & Discussion' started by Tsarbucks, Jul 10, 2016.

  1. Tsarbucks

    Tsarbucks L1: Registered

    Messages:
    14
    Positive Ratings:
    13
    Hello everyone. I recently began mapping and i'm currently working on a KOTH map that I later plan on turning onto a 5cp map.

    Anyways, the point is on the bridge which goes over a 256 hammer unit deep ravine (cylinder). My question is 2 fold. How do I make curving ramps going up to the cylinder and how do I make the cylinder flush with the surrounding ground?

    Cheers!
     
  2. KubeKing

    Server Staff KubeKing dan's birthday was fun

    Messages:
    1,232
    Positive Ratings:
    1,471
    Mr. Stan Lee, is this the tutorial you're looking for?
     
    • Thanks Thanks x 1
  3. Tsarbucks

    Tsarbucks L1: Registered

    Messages:
    14
    Positive Ratings:
    13
    Thanks for the quick reply!
     
    • Thanks Thanks x 1