Tiny props Please help

Discussion in 'Mapping Questions & Discussion' started by THE CHAIRMAN, Jun 27, 2010.

  1. THE CHAIRMAN

    THE CHAIRMAN L1: Registered

    Messages:
    20
    Positive Ratings:
    0
    Im a noob and I bungled something up.. LOL.. I have a pretty nice map going from a structrure standpoint and I have begun to dress it up with some props.

    The problem is when I place a static prop on the map it appears very tiny... Like knee high. If i rewind back to earlier saves, the prop translates normally... full size. I have clicked something and have NO clue what I have changed... No matter what prop or model, its very tiny... ANY IDEAS????

    Thanks in advance..

    THE CHAIRMAN
     
  2. grazr

    aa grazr Old Man Mutant Ninja Turtle

    Messages:
    5,436
    Positive Ratings:
    3,562
    I know this may seem obvious but are you sure it's not a skybox model? It might not be since you say that in previous versions it was the correct size, right?

    But if there are tiny models then chances are it might be a skybox model. Of which are to be used in the 3dskybox and are rendered at 1/16th their proper size.
     
    • Thanks Thanks x 1
  3. Mick-a-nator

    aa Mick-a-nator

    Messages:
    640
    Positive Ratings:
    314
    ^ that.
    and if that isn't the problem, can we see an image of the problem?
     
    • Thanks Thanks x 1
  4. THE CHAIRMAN

    THE CHAIRMAN L1: Registered

    Messages:
    20
    Positive Ratings:
    0
    Thanks fellas... U were correct. skybox model.. didnt know the was a difference. Thanks again!

    THE CHAIRMAN