• Center Save Changes Reset

CTF Sawblade Reserch Lab a1

A mysterious research lab in a mysterious pit in the middle of the desert that researches sawblades.

  1. KYLEWII21

    KYLEWII21 L1: Registered

    Messages:
    16
    Positive Ratings:
    1
    Sawblade Reserch Lab - A mysterious research lab in a mysterious pit in the middle of the desert that researches sawblades.

    (first map I made) ctf map with needlessly complicated logic. After 30 seconds, a mini point is uncovered, and raises into place. (You can go under it, but will be stuck in the corridor for 2 minutes.) Activate the "point" in the middle to gain access to the outer ring and the moat. (for non jumping classes) To get to the flag room for your team, go up the ramp in your spawn room. To gain access to the other team's flag room you need to: activate the "point" in the center, then go to the outer ring/moat, go to the other side of the map, then go up a ramp, past a door, through some hallways, and past a door. To cap the flag, take it to the capture zone in front of the opposing team's base. (via the same hallways) After 5 minutes after the "point" is activated, the outer ring/moat doors, the underwater moat doors, (the hallway that goes across the middle of the map and connects to the moat underwater) and the upper flag room doors close, the "point" deactivates, lowers and gets covered for 2 minutes. (yes, you can get stuck in some places, for two minutes) (yes, you can access the enemy's flag room after the 5 minutes are up, (if you are in the outer ring/moat) but you grant the other team access to the upper area) (I kept adding things, and am now uploading it for testing (a bit late))
     
  2. sooshey

    aa sooshey :3c

    Messages:
    522
    Positive Ratings:
    418
    Make sure your filename is all lowercase because uppercase letters don't work on linux servers. Also add _a1 to the end of the filename and change it for each version so there's no version conflicts. Make sure you do this by saving the .vmf as the correct name first, and then compile. Simply changing the .bsp name will cause issues
     
  3. KYLEWII21

    KYLEWII21 L1: Registered

    Messages:
    16
    Positive Ratings:
    1
  4. Adobe WH

    Adobe WH L1: Registered

    Messages:
    16
    Positive Ratings:
    1
    The LOCATION of your screenshots are fine.
    But a better way to take them, is to type this series in console

    sv_cheats 1
    cl_drawhud 0
    r_drawviewmodel 0
    noclip

    now you can fly around and take screenshots as you wish, and just type

    noclip
    cl_drawhud 1
    r_drawviewmodel 1

    to go back to "game" mode