Payload not moving after first CP

Discussion in 'Mapping Questions & Discussion' started by pancakes, Jul 23, 2011.

  1. pancakes

    pancakes L1: Registered

    Messages:
    2
    Positive Ratings:
    0
    I was making my first Payload map so i naturally looked towards the guide on the source sdk wiki. Sure, everything works well until i capture the first Control point. Then, where the spot where it shows my payload is moving, it shows a blocked sign. My payload doesn't move anymore after that even though there are 2 control points. D: help plz :O
     
  2. Prop

    Prop L3: Member

    Messages:
    109
    Positive Ratings:
    6
    Did you set the next path_track right?
     
    • Thanks Thanks x 1
  3. Loc_n_lol

    Loc_n_lol L10: Glamorous Member

    Messages:
    726
    Positive Ratings:
    273
    Change the trigger capture area's associated control point to the the next one.
     
    • Thanks Thanks x 1
  4. pancakes

    pancakes L1: Registered

    Messages:
    2
    Positive Ratings:
    0
    Bit late, lol, i deleted my whole payload map and switched it to cp but thanks for the replies.
    And i did change the Trigger_capture_areas control point associated with it, but nothing happened. CAn't be bothered now