Output of Spawn Visualizer Will Not Work

Discussion in 'Mapping Questions & Discussion' started by Jasper The Blank, Nov 29, 2017.

  1. Jasper The Blank

    Jasper The Blank L6: Sharp Member

    Messages:
    392
    Positive Ratings:
    197
    delayed again

    I put "Start Disabled" on them, and when a point is capped, I made a relay for a bunch of outputs to turn red's first spawn into blu's. But i compiled and got on red, and couldn't get out because of the blu visualizers. any suggestions?
     
  2. Jasper The Blank

    Jasper The Blank L6: Sharp Member

    Messages:
    392
    Positive Ratings:
    197
    I solved it by myself. I'M SO SMART

    Can I delete this thread now?

    EDIT: K i did this:
    I just used 1 Visualizer (1 for each door) and 1 Spawnroom
    I linked all visualizers corresponding with the spawnroom linked to it.
    Then I made an output when the point is capped, the spawnroom team is changed to blue, so the visualizers will update to block the red and not the blue.
     
    Last edited: Nov 30, 2017
  3. Faux Rhinoceros

    aa Faux Rhinoceros Also known as Dr. Element

    Messages:
    1,477
    Positive Ratings:
    1,367
    Rather than deleting the thread, you should describe how you solved the problem.

    This thread might just help others in the future.
     
  4. Jasper The Blank

    Jasper The Blank L6: Sharp Member

    Messages:
    392
    Positive Ratings:
    197
    Wait hold up now it broke, spoke too soon.
    I put an output saying the red respawn trigger will set the team to 2, which is the team number for blue. BUT IT DIDN'T WORK.
    Then I put Blue instead of 2, and it STILL DIDN'T WORK.
    How do I correctly change the respawn trigger team?
     
  5. Jasper The Blank

    Jasper The Blank L6: Sharp Member

    Messages:
    392
    Positive Ratings:
    197
    I don't need this anymore. You can still answer it! (Maybe not) I gave up on looking for an answer so I just made red have 1 spawn instead of 2 temporary spawns.