mac-10 weapon WIP

Discussion in 'Models' started by chinese_lover, Aug 20, 2008.

  1. chinese_lover

    chinese_lover L1: Registered

    Messages:
    4
    Positive Ratings:
    0
    been working on this weapon in 3dsmax,
    about time to start unwrapping then texturing it,
    its at 4,000 tri,
    this will be my 1st model to put into TF2 or HL2,
    you guys think that is about right for a weapon tri count,
    also if i make it for tf2 how should i paint the textures,
    i read it uses phong shaders,
    Thanks,Chris
    [​IMG]
    [​IMG]
     
    Last edited: Aug 20, 2008
  2. chinese_lover

    chinese_lover L1: Registered

    Messages:
    4
    Positive Ratings:
    0
    ok here are 2 wire shots,
    hope this helps little more,
    [​IMG]
    [​IMG]
     
  3. DJive

    aa DJive Cake or Death?

    Messages:
    1,466
    Positive Ratings:
    736
    lolololol.

    ^ im laughing at the thought of a the sniper carrying around a Mac-10, not the model.

    Model is looking great =)
     
  4. luxatile

    aa luxatile deer

    Messages:
    2,289
    Positive Ratings:
    1,349
    I think it looks great! Are you planning on switching out a TF2 weapon model with this one?
     
  5. chinese_lover

    chinese_lover L1: Registered

    Messages:
    4
    Positive Ratings:
    0
    yeah i was hoping to add it so i could use it in game,
    would i need to take out a tf2 weapon to do this,
    ive never do much modding in this engine,
    most all my work has been done in ue3 engine,
    Thanks,Chris
     
  6. Galago

    Galago L2: Junior Member

    Messages:
    90
    Positive Ratings:
    5
    That's a good model.
     
  7. chinese_lover

    chinese_lover L1: Registered

    Messages:
    4
    Positive Ratings:
    0
    i had to remake the model,
    my hard drive went out,
    lost all my models i was working on,
    remodeling everything isnt fun,