Hammer Model Lag

Discussion in 'Mapping Questions & Discussion' started by Nixon, Aug 4, 2018.

  1. Nixon

    Nixon L3: Member

    Messages:
    116
    Positive Ratings:
    81
    When higher poly-count models are being drawn, hammer's 3D view slows down to a crawl, but only when I'm selecting something. By higher poly-count I mean average LOD models. Never had this problem on my old computer. TF2 runs on average at 200 FPS+. Not sure what to do :/
     
  2. ics

    aa ics http://ics-base.net

    Messages:
    814
    Positive Ratings:
    514
    Make sure you dont have the radius culling enabled. Its the R with red circle around it. Disable if its enabled. Press 1 or 2 to decrease and increase draw distance, that also helps.
     
  3. Nixon

    Nixon L3: Member

    Messages:
    116
    Positive Ratings:
    81
    not radius culling