filling a hollow object?

Discussion in 'Mapping Questions & Discussion' started by ProselyteCanti, Nov 22, 2014.

  1. ProselyteCanti

    ProselyteCanti L2: Junior Member

    Messages:
    91
    Positive Ratings:
    10
    Like for example, a 360 degree arch (circle) is automatically just a circle. I've tried using the vertex tool to change it to a solid object, but that just messes the whole object up. I guess I could try making it myself, using a circle arch to carve a normal square block. But I'm kinda afraid of using the carve tool anymore because of how much it messes up.
     
    Last edited: Nov 22, 2014
  2. Ynders

    aa Ynders absolutely gormful

    Messages:
    403
    Positive Ratings:
    518
    If I understand your problem correctly, then you could just use the cylinder tool.
     
  3. ProselyteCanti

    ProselyteCanti L2: Junior Member

    Messages:
    91
    Positive Ratings:
    10
    Yeahhh that was it. I figured that out about two minutes after I made this thread.
     
    • Thanks Thanks x 1