Cut out section of a brush?

Discussion in 'Mapping Questions & Discussion' started by Chr0matic, Mar 14, 2020.

  1. Chr0matic

    Chr0matic L1: Registered

    Messages:
    1
    Positive Ratings:
    0
    Hello, i'm a newbie to using hammer. I'm wondering if there's a way I can make a cutout of a brush (for doorways, holes, ect.)
     
  2. Heron

    Heron L6: Sharp Member

    Messages:
    371
    Positive Ratings:
    242
    You'll want to use the Clipping Tool (Shift + X) and drag over what you want to be cut, if one side of the line's red in the 2d view, hit Shift + X again until both are white, and hit enter, a side which is red will be deleted. If used properly a doorway should look something like this, after this just delete the brush where the doorway should be.
    Annotation 2020-03-14 234854.png
    Also please never use Carve
     
    Last edited: Mar 15, 2020