Capture Point Layout

Discussion in 'Mapping Questions & Discussion' started by TheRaymond, Feb 7, 2012.

  1. TheRaymond

    TheRaymond L1: Registered

    Messages:
    2
    Positive Ratings:
    0
    Dear Person who may help me,

    I have a problem with the capture point layout on the control_point_master entity. Every time I plug in a figure "0 1, 2, 3 4" the system overlaps 0 and 4 in the same place. As I dont have a screen shot, basically, 0 and 4 are on the left side, and 1/2/3 are clearly shown...its been confusing me as much as doors. It took me 3 hours to figure out that trigger_multiple on doors were preset to -1 for "delay before reset". Yes can anyone help me?

    [​IMG]
     
    Last edited: Feb 7, 2012
  2. Sergis

    aa Sergis L666: ])oo]v[

    Messages:
    1,871
    Positive Ratings:
    1,131
    are the indexes in the CPs themselves set up correctly?

    and i think you shouldnt have space after commas