- Oct 29, 2010
- 2
- 0
Dear Person who may help me,
I have a problem with the capture point layout on the control_point_master entity. Every time I plug in a figure "0 1, 2, 3 4" the system overlaps 0 and 4 in the same place. As I dont have a screen shot, basically, 0 and 4 are on the left side, and 1/2/3 are clearly shown...its been confusing me as much as doors. It took me 3 hours to figure out that trigger_multiple on doors were preset to -1 for "delay before reset". Yes can anyone help me?
I have a problem with the capture point layout on the control_point_master entity. Every time I plug in a figure "0 1, 2, 3 4" the system overlaps 0 and 4 in the same place. As I dont have a screen shot, basically, 0 and 4 are on the left side, and 1/2/3 are clearly shown...its been confusing me as much as doors. It took me 3 hours to figure out that trigger_multiple on doors were preset to -1 for "delay before reset". Yes can anyone help me?
Last edited: