- Jan 20, 2010
- 1,317
- 902
So I am attempting to make a spiral ramp. Sorta like so:
Problem is, when I make it with the vertex editor I get invalid solids. Anyone have any idea how I could go about making this?
To explain the process I made before:
Made a 180 degree arch with 16 sides. Took vertexes from one side and shifted them up 14 units. Did the same with the next one, etc etc, until it was a sloped spiral. However, they are all invalid solids. :facepalm:
Problem is, when I make it with the vertex editor I get invalid solids. Anyone have any idea how I could go about making this?
To explain the process I made before:
Made a 180 degree arch with 16 sides. Took vertexes from one side and shifted them up 14 units. Did the same with the next one, etc etc, until it was a sloped spiral. However, they are all invalid solids. :facepalm: